2. (b) We need to use Synchronous Time Division Multiplexing to combine 17 different channels, where 10 channels are each of 300 Kbps and 7 channels are each of 600 Kbps. A unit is 1 bit. Now, answer the following questions using multilevel TDM with no synchronization bit. Your answers must have units. i) What is the output frame duration? ii) What is the output frame rate? iii) What is the output bit rate? iv) What is the output bit duration? v) What is the size of an output frame in bits? vi) What is the input bit duration?

Q: 5. Suppose, you have 6 voice channels, each of 60MBps. You have to use synchronous TDM to multiplex…

A:

Q: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: a. The size of an output frame in bits is as follows : Size of an output frame = Number of sources +…

Q: Assume that the data is transferred using 16PAM (16-level pulse amplitude modulation). How many bits…

A: ANSWER : The number of possible pulse amplitudes in analog PAM is theoretically infinite. Digital…

Q: Assume that the data is transferred using 16PAM (16-level pulse amplitude modulation). How many bits…

A: Note: As you have asked multiple questions, as per our policy, we will solve the first question for…

Q: distance between the two stations is 10000Km. There are two intermediate switches which A 100MB of…

A: The answer is given below.

Q: The Asynchronous Transfer Mode (ATM) uses an 8-bit CRC for error detection. The 8 bit CRC uses the…

A: Asynchronous transfer mode (ATM) is defined as the method of switching used by telecommunication…

Q: 4. There are four sources, each creating 500 characters per second. If the interleaved unit is a…

A: Data rate :  Data Rate is the  as the amount of data transmitted during a specified time period over…

Q: Six channels, each with a 200 kHz bandwidth are to be multiplexed using FDM together. What is the…

A: It is an analog technique that can be applied when the bandwidth of a link (in hertz) is greater…

Q: For the following stream of digital signal which is being transmitted by bit rate 5 Kbps:…

A: a. Draw waveform for all line code is self synchronized or not.

Q: Bandwidth of PAM signal with pulse train (0.03TS) for analog signal fm = 3.4 KI %3D

A: bandwidth of PAM signal with pulse train (0.03Ts) for analog signal fm=3.4KHz

Q: spectrum of the periodic signal answer the following for one time domain: -

A: Sampling frequency  The minimum frequency at which there is no aliasing effect Sampling frequency is…

Q: 5. Suppose, you have 6 voice channels, each of 60MBps. You have to use synchronous TDM to multiplex…

A: The solution is given in the next step

Q: The Asynchronous Transfer Mode (ATM) uses an 8-bit CRC for error detection. The 8 bit CRC uses the…

A: Asynchronous transfer mode (ATM) is a transfer mode for switching and transmission that can…

Q: List the three main multiplexing techniques  Compare FDM, TDM, and WDM based on: What types of…

A: Solution 1 :  Maximizing Customer Engagement on Social Media Platforms : 1 ) Creating a Strong…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: ans given below

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A:

Q: SAMPLE DATA HELLO CODE

A: A)in below figure shows how to transit message  are multiplexed into frames.

Q: we use synchronous TDM and combine 20 digital sources, each of 100 Kbps. what will be the minimum…

A: It is defined as a multiplexing technique by which multiple data signals can be transmitted over a…

Q: Exercise (1): A line has a Signal-to-Noise ratio 35dB and a bandwidth of 4000HZ, what is the maximum…

A: Data rate governs the speed of data transmission. A very important consideration in data…

Q: Match the given baud rate and the number of bits carried by each signal unit (baud rate, bits) with…

A: 1) bit rate=baud rate x no of bits per signal             =1200*3             =3600  (Answer 1) 2)…

Q: -A synchronous TDM with four 2 Mbps data stream inputs and one data stream output. The multiplexing…

A: Here we have given the answer for the first question as per the guideline.

Q: Suppose two users in a Direct Sequence-CDMA system have signatures (that is, sequences of chips)…

A: Actually, given question regarding CDMA.

Q: 2. (a) Suppose a radio channel occupies a bandwidth of 11 kHz. We need to multiplex 14 radio…

A: As required, I'm providing both answers with all subparts. I hope this will be helpful for you...

Q: 101110111101 11111110000 1010000001111 termine the number of output frames. hat is the output frame…

A: Each output slot is only 10 bits long. (3 bits taken from each input pulse 1 framing bit).   Here we…

Q: Suppose a 128-kbps point-to-point link is set up between the Earth and a rover on Mars. The distance…

A:

Q: A group of some stations share a 56 kbps pure ALOHA channel. Each of these stations output a 1000…

A:

Q: Question 04. We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each…

A: Given that Digital sources count = 20, Each source is of 100kbps,  Bits carried by each output slot…

Q: Consider a geostationary satellite-based system. Earth stations are multiplexing digital information…

A: Given ,A geostationary satellite-based system .And a earth station is multiplexing the digital data…

Q: We have 14 sources, each creating 500 8-bit characters per second. Since only some of these sources…

A:

Q: ith a bit rate of 250 kbps and four with a bit rate of 500 kbps are to be combined using…

A: a) we can allocate eight 250kbps sources into 4 500 kbps sources . Therefore 8 total 500 kbps…