Choose the right answer:1- In autonomous systema- Sensors are used to measure the system output. B.b- The output is not measureable.c- The input has an effect it its performance.d- None of them.2- A unity positive feedback system with a plant G(s) has transfer function:G(s)G(s)+11+G(s)b- 1d- None of all above.a-G(s)3- The RL circuit with an output voltage accross L hasa- pole only. b. zero only c. pole and zero d. not pole nor zero4- A system with state matrix A = is in--a- critical damped b-under damped c-over damped d- undamped-case.[1 015- A system with input matrix B = 0 1 has-lo o]c- three inputsa- one input b- two inputsd- six inputs

Answered: Image /qna-images/answer/0f123a2f-578c-4848-b2da-89894aab73fd.jpg

Answered: 2- A unity positive feedback system…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the system shown in Figure 2, suppose that R(s) is the reference input signal and the D(s) is the disturbance input signal, with K and K, to be decided. D(s) R(s) E(s) u1(s) (s) Y(s) --2z + 2u K K Figure 2: 1 1). Find the closed-loop transfer functions G1(s) and G2(s) in E(s) = G1(s)R(s) + G2(s)D(s). 2). What are the damping ratio ( and natural frequency wn of this system ? Discuss the impact of K and K, on ç and wn. 3). Discuss the impact of K and K, on the tracking error e(0) for a unit-ramp reference signal and a unit-step disturbance signal.
I need the answer as soon as possible
Find the value of a and K so that the unity feedback system have sustained oscillation at 2rad/s. The open loop traansfer function is given K(s + 1) G(s) = s + as? + 2s + 1
A unity negative feedback system has an open loop transfer function k s(s+10) for the system to have a damping ratio of 0.25 the value of k must be Select one: a. non of the choices b. 200 c. 10 d. 100 e. 400 G₂
Exercise 4
R, OV OUT + Complete the analysis showing that Vo/Vin = -Rf/Rin Let currents be defined as 1 equals the current flowing through Rin from left to right 12 equals the current flowing into the Opamp 13 equals the current flowing through the feedback resistor from left to right. Write the KCL equation in terms of 11, 12, and 13 at the inverting node of the Op-Amp. O There is no current flowing in the circuit O 12 = 11 + 13 O 11 = 12 + 13 11 + 12 = 13
Q1) A closed loop system is shown below the input is R(s) and the output is Y(s) (s + 1) (s + 4) 1 1 (s – 3) Y(s) a) Determine the closed loop transfer function R(s) b) Derive the equivalent state space model c) Hence from the state space model Sketch a block diagram model for the system
Report for Electronics As assignment for the students of submit stage, All Students maximum due date of May 14, 2023 must each student should solve this sheet. an Q1/ What is bit is 5V- four the output voltage for digital-to-analog Convertor if the input (1101). Consider Rf = 1kv and R= pkr. Qz/Write down the ideal op amp. 7-12 P/4 R18 ling IM2 all the problems inside characteristics 16 V 201 2nd and 3rd the report with at 11:59 PM. 2km Figure (2) Q3/ For the JFET transistor shown in figure (1), find the following :- VGsQ, IDQ; VDS, VG, VND and Vs. 3.3K Rf IDSS to ma Vp = -8 A Iku a Figure (1) Q4/ for the self-bias configuration shown in figure (3); Find the following:- VGS, IDq, VDS, VG, VD, VS. of the Vout 2/1
Q1- Draw the root-locus with all details for the positive values of gain for the system given by the open loop transfer function: K(s² – 8s + 15) | (s² + 3s + 2)
Q3: Draw the root locus for a control system of open loop transfer function below with unity feedback: G(S) K(2S+5) S(S²+45 + 3) (5² +45 +20)
O b. Kp-1.7 & Kd-0.8 O c. Kp-2 & Kd-4 O d. Kp=7.7 & Kd-3.8 Given the shown circuit and its feedback block diagram, find the transfer function in the block B2. Type: a, b, c, d, e, f or g. Cs I(s) Vin(5) Vour(s) I(s) B1 B2 Vin(s) Ls R Vout(5) RLS e) R+ Ls R a) RCS b) Ls c) Cs d) RLS + 1 9) R+Ls RCs 1 Answer: A Proportional-Integral (PI) controller increases the speed of the system's response. Select one: of O True O False 9:17 PM 4 d) A ENG 19-Apr-2021

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS