18 - chapter28-question19Calculate the power (in W) dellvered to 4 n resistor in thecircuit shown in Figure.a2.004.0 V2 4.0012.0 VOption1 Option2 Option3 Option4 Option54.161012Ob10.0 0a) O Option3b) O Option4011c)Option1d) O Option2e)Option5O Boş bırak

Answered: Image /qna-images/answer/778d68e7-0f38-4f4c-b796-bf0d6df9794c.jpg

Answered: 18- chapter28-question19 Calculate the…

Science

Physics

18- chapter28-question19 Calculate the power (in W) dellvered to 4 0 resistor in the circuit shown in Figure.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 3CQ: Show that the power dissipated by the load resistor is maximum when the resistance of the load...

See similar textbooks

Related questions

Q: Problem 1. What is the equivalent resistance of the combination of resistors between points a and b…

A: resistance of each resistor = R the two resistors near to B are in parallel, their equivalent…

Q: 10) The voltage I'in a simple clectrical circnit is slowly decreasing as the battery wears out The…

Q: 40- How many microC is the charge on the capacitor C2 in the given circuit? A) 4 B) 15 C) 36…

Q: 10 MQ 5000 V I Tov 200 kQ Figure 1: Circuit diagram What is the voltage across the lower resistor in…

A: Given data: Two resistors are connected in series R1 = 10 MΩ = 10,000 kΩ R2 = 200 kΩ Battery…

Q: 16. a circuit consisting of a battery with an emt of 12V, a vesistor with a resistance of 1.2h2, a…

A: A circuit consisting of a battery with a voltagea resistor of resistanceAnd two capacitors with…

Q: 5. Complete the table using the given three resistors and a power supply below with their respective…

Q: earning Portal Courses Reports - e-Services - Academic Departments - ETC CIMS - During an experiment…

Q: 1. Determine voltages in circuit below, given: C1 = 10uF, C2 = 8.33uF, C3=10uF, C4=20F + Vi C3 C2…

Q: A 1 uF capacitor is connected in series with a 2 uF capacitor and an open switch. Initially, the…

A: Step 1: Step 2:Thank you Step 3: Step 4:

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A small office-building air conditioner operates or 408-V AC and consumes 50.0 kW. (a) What is its effective resistance? (b) What is the cost of running the air conditioner during a hot summer month when it is on 8.00 h per day for 30 days and electricity costs 9.00 cenls/kW h ?
The [R drop across a resistor means that there is a change in potential or voltage across the resistor. Is there any change in current as it passes through a resistor? Explain.
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
A 20.00-ohm; 5.00-watt resistor is placed in series with a power supply, (a) What is the maxim tun voltage that can be applied to the resistor without hanniug the resistor? (b) What would be the current through the resistor?
What would be the maximum cost of a CFL such that the total cost (investment plus operating) would be the same for both CFL and incandescent 60-W bulbs? Assume the cost of the incandescent bulb is 25 cents and that electricity costs 10 cents/kWh, Calculate the cost for 1000 hours, as in the cost effectiveness of CFL example.
Suppose you measure the terminal voltage of a 3.2G0-V lithium cell having an internal resistance of 5.00 by placing a 1.00-k voltmeter across its terminals, (a) What current flows? (b) Find the terminal voltage, (c) To see how close the measured terminal voltage is to the emf, calculate their ratio.
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is the current to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
A 500- resistor, an uncharged 1.50-F capacitor and a 6.16-V emf are connected in series, (a) What is the initial current? (b) What is the RC time constant? (c) What is the current after one time constant? (d) What is the voltage on the capacitor after one time constant?
Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
(a) F ind the voltage drop in an extension cord having a 0.0600-O resistance and through which 5.00 A is flowing. (b) A cheaper cord utilizes thinner wire and has a resistance of 0.300 O. What is the voltage drop in it when 5.00 A flows? (c) Why is the voltage to whatever appliance is being used reduced by this amount? What is the effect on the appliance?
Integrated Concepts (a) An immersion heater utilizing 120 V can raise the temperature of a 1.00 102 -g aluminum cup containing 350 g of water from 20.0°C to 95.0°C in 2.00 min. Find its resistance, assuming it is constant during the process. (b) A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.
Solve Example 21.5, but use loop abcdefgha instead of loop akledcba. Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.