134) VR(E) -> Vsilt) = 10o cos (5000t+ 53,13TT いVgt) =8sinlsco0 +)< %3D 180 a) Find the mathematical expresion for the cusrent igLt) 6) Calculate the complex power Vsilt) on the voltoge source

Q: Andrei took me out to lunch. I went to see Andrei. Andrei took me out to lunch, before I went to see…

A: Option d Andrei took me out to lunch , I went to see andrei Explanation:  Action 1: speaker went to…

Q: What did you learn about the Republic Act No. 7920? "New Electrical Engineering Law." (150 words)

A: New electrical Engineering law:  In this law provision of composition, power, and function of the…

Q: Write the different types of circulators and explain its operation.

A: According to guidelines we need to solve only the first question. According to the question we need…

Q: Can you please picture the solution again? because it's too vague, I can't read very well. Thank…

A: It is asked to picture the provided solution again.

Q: Q2) Explain the The difference between power signal and energy signal (with equations) i) i) Unit…

A:

Q: When using my instrument for measurement and testing of an electrical circuit, your should be…

A:

Q: What are the different Alternating Current consumers (devices/systems) in the aircraft electrical…

A:

Q: If an analog linear measuring instrument has linear voltage measuring function Vout = Kx + Vo for…

A: The concept of this problem lies in the definition of voltage and ground. The ground is the…

Q: (a) Spectrometer uses a fiber optic cable to connect the lens and spectrometer (see figure below).…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: •) Describe the Hall effect. Draw a iagnam to illustrate your answer.

A: In the captivating world of Electronics and physics, where electricity and magnetism play an…

Q: Analyze the different semiconductor technologies, such as silicon, germanium, and gallium arsenide

A: In the given questions we need to Analyze the different semiconductor technologies, such as silicon,…

Q: The scale of moving iron instrument is linear.

A: Moving Iron Instrument:

Q: The required voltages are measured at both ends The resistance is (40 kOhm) by using a voltmeter…

A: Calculate the output voltage across the 40kΩ resistor using the voltage division rule.…

Q: Differentiate analog systems from digital systems. Provide points to your claims.

A: Both digital and the analog systems are used to transmit and received information (or signals). The…

Q: A long, inexpensive extension cord is connected from inside the house to a refrigerator outside. The…

A: The resistance of the extension cord depends on, R=ρlA Here, ρ is the resistivity of the cord, lis…

Q: You are given a length of uniform heating wire made of a nickel-chromium-iron alloy called Nichrome;…

A: Given resistance of a wire R= 79.03ohms  Potential difference,V= 115 volts. The energy dissipation…

Q: Determine which options best match each of the statements related to turning off independent sources…

A: Process of turning on and off of the voltage source,

Q: how to find current ina circuit

A: In a circuit, current can be found by computing the values of resistance and voltage in the circuit.…

Q: Give two examples of engineering courses that are: Purely qualitative Purely mathematical…

A: 1) A.Professional Ethics B. Managerial Economics and Financial Analysis

Q: can i see the solution?

A:

Q: is required to stabilize an absolutely unstable system to achieve a specified performance.

A: The given question is solved below according to the given parameters and instructions in the…

Q: What are the reasons for the engineer's request to the technician to implement an electrical…

A: An engineer whether employed independently or for a corporation has to handle some ethical problems…

Q: 24 * Which of the following will not affect the resistance of the wires in the electrical circuit…

A: The resistance of a wire is directly proportional to resistivity of the wire and length of the wire…

Q: an you please appear the solution. Thanks

A: L=5 H,R=16 Ω,E=120 Volts.

Q: 5- Describe abbreviate the function of each block shown below: Scope Mux Product

A: There are various blocks which can be used in matlab simulink for the simulation of particular…

Q: Solve question (1).

A: Based on the power supply, the electrical instruments can be classified in three categories: 1. The…

Q: Draw the schematic diagram of the following.

A: Introduction: In a single-phase supply, there are mainly two conductors:  Phase wire: The phase…

Q: 2- What are the components of the mobile power circuit (the power circuit)?

A: A mobile power circuit is basically a switch mode power supply. Which contains the main components…

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: Draw and Illustrate the block diagram of the following. 1. External Device

A: Types of system Lines  Address line Data line Control line All the systems lines are connected to…

Q: Compare the distribution of charges, electric field and potential of an abrupt junction, one sided…

A: Part 1: Abrupt Junction: When an N-type semiconductor and a P-type semiconductor comes in contact,…

Q: Identify whether each of the pole–zero diagrams shown in the image provided represent a stable…

A:

Q: I have 2 VRF heat recovery units with specs as follows: RLA = 0.2 %3D V = 208 PH = 1 HZ = 60 How…

A: As from given data, VRF heat recovery units are working on 208 V, single phase Therefore no.of poles…

Q: A 616 meter is having an accuracy of ± 0.16% of FSD. Calculate the %error for a measurement of 12,…

A: Error for 616 range is, Error=616*0.16100=0.9856 Full scale error valueAccuracy=0.9856100-0.16…

Q: In the figure shown below, what is the magnitude and direction of the net Coulomb force vector acted…

A: In the figure,  Total net force on the centre due to circumference charge. If radius r= 100cm.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.