1. The cable is attached to a fixed support at A and a moveable support at 8. if the cable is 80-ft long. F (force) weighs 0.3 b/t, and spans 50 ft, determine the force F holding the moveable support in place. Also determine the sag Ans. d-28.22 ft; Fn4.27 ib

Q: 5-5. The cable supports the three 1loads shown. Determine the sags yg and yp of points B and D. Take…

A:

Q: 3-51 Determine the greatest force F that can be applied to the ring if each cable can support a…

A: To determine the greatest force F for the given maximum allowable load of each cable.   Given,…

Q: Cable ABCD supports the loading shown. determine the tension in member BC, angle B1 and B2

A: To find tension in cable BC and angle beta 1 and beta2

Q: A flexible cable is subjected to a uniformly varying load. If the tension at the supports is 12 kN,…

A:

Q: H.W.2: A gat (AB) is supported by pin (A) of diameter (16mm) cable with double shear and cable at…

A:

Q: H.W.2: A gat (AB) is supported by pin (A) of diameter (16mm) cable B with double shear and cable at…

A: We have to find the value of maximum allowable load according to the given data in the question.

Q: Compute the maximum loading (kN) in the cable. E 1.5 m C 1 m 4 kN -5 m -4 m -4 m

A: To find maximum loading in cable

Q: As shown below, the cable AE supports three vertical loads from the points indicated. Determine the…

A: The cable is the flexible member which mainly resist the tension force and not the compression…

Q: 2-130. Determine the angles and made between the axes OA of the flag pole and AB and AC,…

A: Given : To Find : Determine the angle between the axes OA of the flag pole and AB and AC of each…

Q: Determine the maximum and minimum tension in the cable.

A: Beam with both the end fixed with a universal load of 16KN/m over the span of 20m.

Q: Question 3 The cable BC exerts a 1600 lb force F on the hook at B. Determine rAB X F. 6 ft FAR 12…

A:

Q: 4-3* Two ¹/4 -in.-diameter steel cables A and B are used to support a 220-lb traffic light as shown…

A:

Q: Neglecting the weight of the frame find the tension in cable CD. 9 ft 9 ft 200 lb/ft 18 ft 12 ft- 12…

A:

Q: A cable supports two vertical loads as shown in Fig. If the maximum tension in the cable is 2000 lb,…

A: The given figure is shown below:

Q: Maximum Tension T L2 L1 Angle A The boom is intended to support two vertical loads, F1 and F2. If…

A:

Q: 5-43. The boom is intended to support two vertical loads F₁ and F₂. If the cable CB can sustain a…

A: Given ; Max.. load sustained by cable CB = 1500 N If F1 = 2F2 What is the magnitude of max. reaction…

Q: The pipe ABCDE is supported by ball-and-socket joints at A and D and by cable ECF that passes…

A: Given:Required:Force diagramMagnitude of concentrated force FCDTension forces in terms of TNote: As…

Q: Ex. Calculate tension in each segment of cable and vertical sag at B. hs B 3kN 8kN 2m

A: Given :

Q: The 10 kg/m cable is suspended between the supports A and B. If the cable can sustain a maximum…

A: The load on the cable is calculated as,

Q: ZAHN P1-53 with its the two 100-lb forces with a single fom through G and a couple whose forces act…

A:

Q: Determine the value of Tension 1 in segment AB for the cable shown h A 2m S B 3KN 2m C 1.5 m 0₁ 8 KN…

A: Given Data  Find the tension in segment AB (T1)

Q: 4. Determine tho B1. B2. B3 &B4, forces in each segment and the total length of the cable. I y=15m…

A:

Q: A- In Fig.A , Replace the loading system by an equivalent resultant force and specify where the…

A: The resultant line of action intersects the member AB measured from A -

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.