. Calculate minimum and maximum frequency for acoustic and optic mode.
Q: 1. Drive Kirchhoff's integral theorem for diffration. And writes its application to rectangular…
A: Kirchhoff's integral theorem, sometimes referred to as the Fresnel Kirchhoff integral theorem,uses…
Q: 2. What should be the value of the fiber radius of a single mode fiber with refractive indices of…
A:
Q: You can hear around corners, but you can't see around corners. Why?
A: Waves are capable of bending around obstacles. This effect is called diffraction. Light consists…
Q: 400 nm 500 nm 600 nm 700 nm 1. Wavelengths: Blue Yellow Red purple blue
A: A single wavelength can give a spectrally pure or monochromatic color.
Q: 1. What is necessary for true diffraction to occur?
A: Condition required to occurs diffraction of light are . 1)Diffraction effect depand upon he size of…
Q: Snell's law describes. .. A. magnification. B. reflection. C. refraction. D. Huygen's wavelets.
A: Concept used: Refraction is the process in which light travels from one medium to another.…
Q: 5. Calculate the wavelength of light that has its third minimum at an angle of 30.0° when falling on…
A: Given:The angle of third minimum is .The distance between slit is d=3.00 μm.In the double-slit…
Q: State Bragg'
A: Required : Bragg's law of diffraction.
Q: Approximately what is the smallest detail observable (in m) with a microscope that uses ultraviolet…
A: Given: Light frequency f=1.11×1015Hz To find: The smallest detail available with a microscope (In m)
Q: The wavelength of a light in air is 631 nm. What is its frequency? O none of these 121000 Hz…
A:
Q: 2. Sketch the f v.s. Uind graph for given data table. Determine the value of po and calculate the…
A: The graph for the given table is as follows:
Q: If the quality factor of the Nd: YAG (1.064 um) laser is (Q=1.85x10) with a length resonator (Im),…
A: The quality factor of the laser is given by:
Q: 5) Lithotripsy is a noninvasive medical procedure that is used to break up kidney stones in the…
A: The equation of an ellipse is: x-h2a2+y-k2b2=1 where: (h,k) is the center of the ellipse a is the…
Q: 14) Calculate the maximum reflected wavelength by a thin film of refractive index 1.55 and thickness…
A: When interference takes place in thin films the final intensity might increase or decrease.…
Q: 3. In case of the thin films, condition for constructive interference, is when the path difference…
A: To find the condition for constructive interference of thin film
Q: 14. Estimate the linear separation of two objects that the human eye can resolve at a distance of 1…
A: Given data: The diameter is, D=5 mm The radius is,r=2.5 mm The distance, d=1 m The wavelength is,…
Q: Two in-phase sources emit electromagnetic waves of equal wavelength and intensity. At the position…
A:
Q: What is the frequency of 560 nm yellow- green light?
A: Given: Wavelength of yellow-green light, λ=560nm=560nm×10-9mnm=5.6×10-7m
Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…
A: The radar in which both transmission and reception is done using the same antenna are called: a)…
Q: 12) Calculate the maximum reflected wavelength by a thin film of refractive index 1.4 and thickness…
A: In a thin film, light waves are reflected from the background and the film is capable of interfering…
Q: 4. Calculate the frequency of a sound wave that has a wavelength of 3.00 cm, take vsound = 343 m/s.…
A:
Q: 6. Given the boundary condition for the wave guides that El = 0 and B = 0 (a) Set the equation for E…
A:
Q: 1- .S is defined as the ratio of the velocity of light in vacuum to the velocity of inder light in…
A: Refractive index of a material is the measurement of how fast light travels in a medium. Fiber…
Q: 10. The closest distance a book can be read from a pair of reading eyeglasses (Power = 1.82 dp) is…
A: Given data: The lens power P=1.82 dp The distance between book to eye is d=25+3=28 cm=0.28 m
Q: Put the following wavelengths in order from lowest to highest energy. 625 nm 4.40 mm Choose...…
A: λ1 = 625 nmλ2 = 4.40 mmλ3 = 7.50 x 103 m λ4 = 9.15x107 m
Q: ) There was a major collision of an asteroid with the Moon in medieval times. It was described by…
A:
Q: Assuming amplitudes of two plane polarized lights as ai = az and 0 = 27/3. Plot the values of Ex and…
A: Given, amplitude is the same, a1=a2=a and phase difference, θ=2π3 x-component of the electric field,…
Q: 1. Two coherent radio point sources separated by 2.0m are radiating in phase with a wavelength…
A: ∗Too get a maxima on screen path difference should n λ. When n=0,±1,±2, ‐‐‐‐ Means path…
Q: 3. Write electric field expressions and Jones vectors for the following waves: (a) a linearly…
A:
Q: 6. Determine the frequency of blue light given the wavelength of 450 nm. [1 nm = 1x 10° m and the…
A: Since we only answer up to 1 question, we’ll answer the first question. Please resubmit the…
Q: 10. In a photoelectric effect experiment, it is observed that green light does eject electrons from…
A: There is a maximum value of the wavelength of the incident wave for which photoelectrons elected.No…
Q: 3. In a photoelectric effect experiment, it is observed that violet light does not eject electrons…
A: We know photons have energy. When it is incident on the photosensitive metal photoelectrons are…
Q: Determine the remaining intensity of the light leaving through 8.3Km optical fiber if the…
A: Given data: Length of the fiber, L=8.3 km Attenuation, α=6.1 dB/km Our question is to find the…
Q: Suggest A selector for determining the wavelengths of emission lines at 559.0 nm and 559.5 nm. A.…
A: Introduction: The wavelength of 559.0 nm and 559.5 nm is approximately between the UV range or the…
Q: 2. In Young's double - slit experiment, derive the equation for destructive interference.
A: We need to find the equation/condition for destructive interference in Young's double-slit…
Q: 18- In which of the following parts of the complete oscillation cycle of the oscillator, the current…
A: Given: Four conditions of oscillator are there.
1. Calculate minimum and maximum frequency for acoustic and optic mode.
Step by step
Solved in 4 steps with 1 images
